How to Clean your Car | Car Cleaning Tips

Car Engine Cleaning Tips

How to Clean your Car | Car Cleaning Tips

Car Engine Cleaning tips onlineCar Engine Cleaning Tips

For many, everything that is not visible from the outside does not deserve to be cleaned. Beyond the concern for aesthetics, our car has many components sensitive to dirt that can deteriorate severely over time and when we talk specifically about the power plant, the problem takes important dimensions.

If the motor is covered with dust, in the short term it will not affect the operation at all; But over time a solid layer of earth can be deposited in the radiator and generate a loss of cooling, which causes an increase in the temperature of the engine, shortening its useful life and can generate various problems.

In addition, if dirt accumulates in the air conditioning condenser, it can cause the loss of cold air entering the passenger compartment, making this system less efficient and increasing fuel consumption to achieve the desired temperature, as we are forcing others to the team.

On the other hand, if the dirt is due to oil leaks, it can accumulate and mix with dust, mud or dirt, causing damage to the parts of the engine that are made of rubber, rubber, and plastics.

But as in Detail King, we do not like to give you problems, we are going to give you the solution so that you have your engine shining and working as it should:

Write down the ingredients, to clean the engine properly you will need:

  1. Detergent
  2. A plastic bag
  3. Water
  4. Thick aluminum foil
  5. Brush

Let’s go step by step:

1) Start the engine and allow it to warm up a little, but without letting it reach normal operating temperature. You can leave it on for a minute or a little longer if it is very dirty.

Car Cleaning Services Christchurch

2) Place the car in an area where the soap and the material you clean from the vehicle will not cause damage or stains.

3) Remove the cable from the negative terminal of the battery (usually black), then the positive (usually red) and cover the exposed electrical components with the bag or some plastic wrap. This will prevent the battery, fuses and other electrical components of the car from getting wet.

4) cover the air intake and the carburetor (on older engines) with thick aluminum foil or plastic. Water can cause serious problems if it is allowed to enter these areas.

5) To wash: Brush any dirt or debris on the surface of the motor, either using a brush to paint stiff bristles or a brush with plastic bristles for cleaning.

6) Mix 2 cups of anti-grease detergent in 4 liters of water and pass this solution in the dirtiest parts of the engine. Then, the fun part, rinse with a pressure hose without wasting water.

7) Remove the protectors that were used to cover the sensitive components.

8) Start the engine and let it idle so that the moisture evaporates and does not affect any element.

In order to keep the engine clean, a prevention mechanic is always advisable. It is not recommended to clean the motor too often because it has delicate components, which can be damaged if exposed to water. Therefore, the cleaning that is done will depend on the use of the car.

Share this post

Leave a Reply

Your email address will not be published. Required fields are marked *


Call Now Button